Ricoh WG-20 - Changing the Start-Up Screen

238
7
Settings
You can choose the start-up screen displayed when the camera
is turned on.
You can choose any of the following images as the start-up screen:
• The Guide Display Start-up Screen showing a guide to the shooting
modes and buttons
• The pre-installed screen
• One of your own images (compatible images only)
1 In Q mode, press the four-way controller (3).
The Playback Mode Palette appears.
2 Use the four-way controller
(2345) to select
(Start-up Screen).
3 Press the 4 button.
The image selection screen appears.
4 Use the four-way controller
(45) to choose the image
for the start-up screen.
Only images suitable for the start-up
screen are displayed. You can also
choose the pre-installed screen
or the Guide Display Start-up Screen
already stored in the camera.
5 Press the 4 button.
The setting is saved.
Changing the Start-up Screen
2/2
Start-up Screen
For setting a captured
image as the Start-up
Screen
OK
OK
MENU
Cancel
10
1 0
0
-
001
0 0 1
7100
-
0017
MEN
MEN
UMENU
Cancel
Cancel
Cancel
OK
OK
OK
OK
OK
WG20_OPM_ENG.book Page 238 Wednesday, February 5, 2014 2:20 PM