Ricoh WG-20 - Taking Pictures Using the Remote Control Unit (Optional)

97
3
Taking Pictures
You can use the remote control (optional) to take pictures while you are
away from the camera.
1 Press the four-way controller (2) in A mode.
The [Drive Mode] screen appears.
2 Use the four-way controller (45) to select i and press
the four-way controller (3).
• With j, you can continue shooting until the memory capacity
of the SD Memory Card or built-in memory is full.
• The interval of j varies according to the [Recorded Pixels]
and [Quality Level] settings.
• The focus, exposure and white balance are locked with the first shot.
• When the Face Detection function is activated (p.71), it works only
when taking the first shot.
• The Blink Detection function works only for the last shot.
• The number of recorded pixels is fixed at f/ in c mode.
When the shooting mode is set to (Report), the number
of recorded pixels is set to V (1280×960).
Taking Pictures Using the Remote Control Unit
(Optional)
i
3-sec Remote
Control
The shutter will be released after about three seconds when
the shutter release button on the remote control unit is pressed.
h
0-sec Remote
Control
The shutter will be released immediately when the shutter
release button on the remote control unit is pressed.
Four-way controller
4 button
Shutter release
button
WG20_OPM_ENG.book Page 97 Wednesday, February 5, 2014 2:20 PM