101
6
Appendix
Shooting
Problem Cause Solution Page
Shooting cannot be
performed by pressing
z.
The battery is exhausted. Charge the battery. p.33
The camera is turned off or not in
the shooting mode.
Turn the camera on or press z
to switch the camera to the shooting
mode.
p.35
The memory card is not
formatted.
Perform [Format [Card]] of the
E menu.
p.37
The memory card is full. Insert a new card, or delete
unwanted files.
p.68
The memory card has reached
end of its service life.
Insert a new memory card. —
The memory card is locked. Unlock the card. —
The memory card contacts
are dirty.
Clean with soft, dry cloth. —
Images cannot be
checked after shooting.
Confirmation time is too short. Change the setting of [Confirm.
Time] in the D menu.
p.38
The monitor is blank. The monitor brightness is dark. Adjust the brightness of the monitor
in the E menu.
p.83
The monitor is off. Press e to turn the monitor on. p.18
An AV device is connected to
the camera.
Remove the cable from the camera. p.67
The camera is unable
to focus in autofocus
mode.
The lens is dirty. Clean with soft, dry cloth. —
The subject is not at center
of frame.
Lock the focus for shooting. —
The subject is not suitable for
autofocus.
Lock the focus or set the focus mode
to [MF] for shooting.
p.49
The subject is too close. Use [Macro] for shooting or move
away from the subject.
p.47
Images are blurred. The camera was moved when
z is pressed.
Hold the camera with your elbows
pressed against your body, or use
a tripod.
—
When shooting in a dark place,
taken images become easily
blurred.
Use a flash, or set [Setting] to a high
ISO sensitivity.
p.52
p.50
The flash does not
discharge.
The flash is not
charged.
A function preventing flash
operation is selected.
Check the settings and mode. —
The battery is exhausted. Charge the battery. p.33
To Next Page
Loading...
