11
Unpacking and Checking Contents
Tools Needed
Tools Required for Alignment
Unpacking
WARNING: To reduce the risk of
injury from unexpected starting
or electrical shock, do not plug
the power cord into a source of
power during unpacking and
assembly. This cord must
remain unplugged whenever
you are working on the saw.
Your miter saw is shipped complete in one
box.
WARNING: Although small, this
saw is heavy. To reduce the risk
of back injury, get help when-
ever you have to lift the saw
more than 10 inches.
1. Remove the miter saw from the carton
by lifting the saw by the carry handle.
WARNING: If any part is missing
or damaged, do not plug the saw
in until the missing or damaged
part is correctly replaced. To
reduce the risk of electric shock,
use only identical replacement
parts when servicing double
insulated tools.
2. Place the saw on a secure stationary
work surface and look the saw over
carefully.
List of Loose Parts
NOTE: Before beginning assembly, check
that all parts are included. If you are miss-
ing any part, do not assemble the saw.
Call 1-800-4-RIDGID or E-mail us at
info@ridgidwoodworking.com if any parts
are damaged or missing. Sometimes
small parts can get lost in packaging
material. Do not throw away any packag-
ing until saw is put together. Check pack-
aging for missing parts before contacting
RIDGID.
The following parts are included:
Item Description Qty
A Basic Saw Assembly ..........................1
B Owners Manual...................................1
C Accessory Pack ..................................1
Socket Wrench & 1/2" Socket
Medium Phillips
Combination Square
Combination Wrench, 1/4" Hex “L”
Wrench with #2 Phillips tip (supplied)
Combination Square Must be True
Draw Light
Line on Board
Along this Edge
Straight Edge of
Board 3/4" Thick
This Edge Must
be Perfectly
Should be no Gap or Overlap
when square is Flipped Over
Straight
Screwdriver
in Dotted Position
Carry Handle
A
BC
To Next Page
