25
Miter Cut
When a miter cut is required, loosen the
miter lock knob, depress the index spring,
and move the saw to the desired angle.
Retighten miter lock knob. Do not stand in
front of the saw table. Move with the han-
dle to the miter angle to make the cut.
Bevel Cut
When a bevel cut is required, loosen
bevel lock knob and tilt the blade to
desired bevel angle. Lock the bevel lock
knob. Stand to the left side of the handle
to make the cut.
Overriding the Bevel Stops
Use the 0° and 45° bevel stops for pre-
cise, repeatable bevel indexing.
Occasionally, when cutting a bevel or
compound cut, you may need to set the
bevel angle a small amount beyond the 0°
or 45° bevel stop. This is very easily done
by pulling the bevel index pin out and
locking the bevel knob.
Move feet
with
Miter Angle
Bevel Index
Stops
Bevel Index
Pin
Bevel
Lock Knob
Rear, Bottom
View From Back
To Next Page
