RIDGID MS1060 - Assembling Dust Elbow and Dust Bag

14
Assembly (continued)
6. Secure extension arm in place with a
5/16-18 x 1-1/4 Phillips screw and a
flat washer as shown. Do not over-
tighten. Overtightening may damage
the saw.
7. Repeat steps 1-8 for the other side of
the miter saw, omitting step 4 if
already performed.
8. Set the saw back down.
9. Set the stop block at the desired loca-
tion and tighten thumb screw.
Assembling Dust Elbow and Dust
Bag
1. Locate the dust elbow.
2. Unplug power cord.
3. With the miter arm locked in the
down position, start the dust elbow
onto the dust nozzle at an angle to
retaining lip.
4. Firmly press the dust elbow the
rest of the way onto the second
retaining lip.
NOTE: At first time installation, or if
assembled in a cool or cold climate, the
rubber is not as flexible and will be more
difficult to assemble.
Flat
Washer
1-1/4" Phillips
Clamp
Bracket
Top View
Pull bars up into base grooves with
clamp using screw
Screw
Dust Elbow
Dust
Second
Retaining Lip
Dust Bag
Nozzle