29
Bolero User Manual A20
2.4.9.1 Antenna OTA
This registration mode allows registering a Beltpack at an already registered Antenna over the air (DECT).
Following steps are necessary to register a Beltpack via Antenna-OTA to a Bolero Net:
·
At first the 'Registration Method (OTA)' must be activated. This can be done in two ways:
a) Via the Antennas Web-Interface
(see chapter 'Bolero Antenna > Features in Detail > Registration').
b) Via another Beltpack that is already registered in the Net:
Menu 'Admin > Registration Mode > Over The Air > On'.
·
Then start the registration process in the Beltpack that should be connected to the Net:
a) If the Beltpack is not registered to any Net, press and hold the 'Reply' key for one second. The Beltpack starts
automatically searching for available Nets.
b) If the Beltpack is already connected to another Net, push the Beltpack's Menu key for >3 seconds (long key
press), navigate to the menu 'Registration' and select 'Register to net'.
The Beltpack begins to search for available Nets and displays them one at a time.
·
The Beltpack will continue to search until a Net is found or 'Back' is pressed.
·
If 'Back' is pressed, the Beltpack will stop searching and return to the Registration menu.
·
If 'Next' is pressed, the current Net is blocked and the Beltpack will continue searching for other Nets. The blocking
list is cleared by reentering the Registration menu.
·
If 'Select' is pressed, the user will be asked for the OTA Registration PIN that was defined via the Antennas Web-
Interface or via the Beltpack where the registration mode was enabled (by default the Admin PIN is used).
·
After registration, the Beltpacks are immediately connect to the Bolero net.
·
This setting is system wide and stays active until disabled or the registration timeout runs out.
·
The registration timeout is restarted each time a Beltpack is registered.
To Next Page
Loading...
Need help?
General
