Rigol DS4024E User Manual

Chapter 13 System Function Setting RIGOL
DS4000E User’s Guide 13-3
Network Status
The oscilloscope will give different prompts according to the current network
connection status.
 Net Config Success!
 Acquire IP…
 IP Conflict!
 Unconnected!
 DHCP Fail!
Current IP Configuration Type
Display the current IP configuration type: “DHCP”, “Auto IP” or “Static IP”. “No Net
Config!” is displayed during the configuration process and when configuration error
occurs.
MAC Address
For each oscilloscope, the MAC address is unique. When attributing IP address for
the oscilloscope, the MAC address is usually used to identify the instrument.
VISA Address
Display the current VISA address of the oscilloscope.
IP Configuration Type Status
Display the on/off states of the DHCP, Auto IP and Static IP configuration modes.
To Configure and Apply the Network Parameters
The oscilloscope provides DHCP, Auto IP and Static IP configuration modes. In
different IP configuration type, the configuration mode of the network parameters
(such as the IP address) is different.
 DHCP: the DHCP server in the current network will assign the network
parameters (such as the IP address, subnet mask, gateway address and DNS
server address) for the oscilloscope.
 Auto IP: the oscilloscope will get the IP address ranging from 169.254.0.1 to
169.254.255.254 and the subnet mask 255.255.0.0 automatically according to
the current network configuration. Users can define the gateway address and
DNS server address.

Rigol DS4024E Specifications

General

Brand	Rigol
Model	DS4024E
Category	Test Equipment
Language	English