Chapter 13 System Function Setting RIGOL
DS4000E User’s Guide 13-17
1) Log in RIGOL official website (www.rigol.com); click SERVICE
Software License Register.
2) Input the correct key, instrument serial number (press Utility System
System Info to acquire the instrument serial number) and identifying
code in the interface and click Generate to acquire the option licensing
code as well as the download link of the option authorization file. To use the
option license file, click Download and download it to the root directory of
USB storage device.
3. Install the option
Method 1: Use the option livense
After acquiring the option license, press Utility Options Setup.
1) Press Editor to open the option license input interface as shown in the
figure below.
2) Turn the multi-function knob
to select the specified character and press
the knob to input the character in the “Option License Input Area”. By
default, the characters input are displayed in the area from left to right.
Note: The hyphens are not included in the option license.
During the input, you can press Backspace continuously to delete the
characters in the “Option License Input Area” from the right to the left or
press Clear to clear all the characters in the “Option License Input Area”.
3) After inputting the option license correctly, press Apply and the
oscilloscope will activate the corresponding option using the option license
currently input.
Note: Apply is only available when the option license (28-character) is
input completely.
In addition, you can also send SCPI command to install the option. For the
detailed method, refer to
DS4000E Programming Guide
.
Input Area
Character Selecting Area
To Next Page
Loading...
Need help?
General
