Rigol DS6104 User Manual

RIGOL 7 Protocol Decoding
7-10 DS6000 User’s Guide
I2C Decoding (Option)
I2C serial bus consists of the clock line (SCLK) and the data line (SDA).
Host
Device
SCLK
SDA
A2
A1
A0
Vcc
SCLK
SDA
SCLK: sample the SDA on the clock rising edge or falling edge.
SDA: denote the data channel.
Press MATH  BUS1  Decode to select "I2C" and turn the I2C decoding function
menu on.
If the current trigger type of the trigger system is I2C, press CopyTrig to copy the
current I2C trigger configurations (include the clock signal (SCL) and data signal
(SDA)) to the I2C decoding configurations. After that, you can still set the I2C
decoding parameters according to the introductions below.
Note: The copy function is only available when the current trigger type is "I2C";
otherwise, CopyTrig is not available.
1. SCLK Setting
Press SCLK to select any channel (CH1-CH4) as the clock channel.
Press SCLK to set the threshold of the clock channel.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English