9 Pass/Fail Test RIGOL
DS6000 User’s Guide 9-1
9 Pass/Fail Test
Monitor the change of the signal by judging whether the input signal is within the
mask created. The test result can be displayed on the screen as well as be prompted
by the system sound or the pulse signal output from the [Trig Out/Calibration]
connector on the rear panel.
The contents of this chapter:
To Enable Pass/Fail Test Function
To Select Source
Mask Range
Test and Output
To Save the Test Mask
To Load the Test Mask
To Next Page
Loading...
Need help?
General
