59
Measurement
Note
It is also possible to use the Mode key during mea-
surement to read the equivalent continuous sound
level up to that point. (This applies only to the nu-
meric level display. The bar graph indication shows
the sound level.)
Changing the A/C/FLAT or Fast/Slow setting after
measurement is completed has no effect on the dis-
played processing result.
11. When the measurement is completed, you can use the Mode key to
switch between various ways of displaying the measurement result.
When L
AE
is shown, the sound exposure level is being displayed.
If L
AE
is not shown, check whether L
AE
on the "Display" menu screen
is set to "On".
If "
O v
" (Over) is shown, the sound level data used for processing
contained over-range data.
If "
U n
" (Under) is shown, the sound level data used for processing
contained under-range data.
M a n u
F a s t
O v
3 0
1 2 0
m
U n d e r - r a n g e
s i g n a l i n d i c a t o r
O v e r - r a n g e
s i g n a l i n d i c a t o r
M e a s u r e m e n t s c r e e n
U n
E
S o u n d e x p o s u r e l e v e l
To Next Page
Loading...
