Rishabh RISH CON - I - RS 485 Baud Rate

from 0 through to 9, the value will
wrap from 9 round to 0. Pressing
the “ Up” key will advance the
operation to the next digit and set
the third digit, in this case to “9”.
Enter New/Change Address value,
third digit entered, prompting for
fourth digit. (*denotes that digit will
be flashing).
Pressing the “ Down” key will
scroll the value of the fourth digit
from 0 through to 9, the value will
wrap from 9 round to 0.
Pressing the “ Up” key will
advance the operation to the New/changed Address value
confirmed’ and set the fourth digit in this case to “6”
New/Changed Address value
confirmed.
Pressing the “ Down” key will re-
enter to the ‘New/change Address
value edit”mode. Pressing the” Up
key will confirm New Address value
and advance to Baud Rate
selection (section 3.1.3.2).
3.1.3.2 RS 485 Baud rate
This screen allows the user to set Baud Rate of RS 485 port .
The values displayed on screen are in kbaud Pressing the
“ Down” key will enter the ‘baud Rate edit” mode and scroll the
14