Rishabh RISH CON - I - Current Transducer

1 Introduction
2 Input and Output screens
3 Programming
3.1 Programming via Front LCD & Two keys
3.1.1 Password Protection
3.1.1.1 Password verification
3.1.1.2 Editing Existing Password
3.1.2 Current Transformer parameter
Setting
3.1.2.1 Current Transformer primary
value
3.1.2.2 Current Transformer secondary
value
3.1.3 Communication Parameter Setting
3.1.3.1 Address Setting
3.1.3.2 RS 485 Baud rate
3.1.3.3 RS 485 Parity selection
3.1.4 Output Type selection
3.1.4.1 Output 1 Type selection
3.1.4.2 Output 2 Type selection
3.1.5 Input characteristics Setting
3.1.5.1 End value of input
3.1.5.2 Start value of input
3.1.5.3 Elbow Function Selection
3.1.5.4 Elbow value of input
1
Programmable Current Transducer
Installation & Operating Instructions
Current Transducer
SectionContents