A
3.1.6 Output Characteristics Setting
3.1.6.1 Output 1 Characteristics Setting
3.1.6.1.1 End value of output 1
This screen allows the user to set the End value of Output 1,
(considerd as DC Current).
The End value of Current Output
is fixed at 20mA.
Pressing the “ Down” key value
remains constant because End
value is fixed.
Pressing “ Up” key will confirm
the present value as End value
of the Output 1 and advance to
the Start value of Output 1 setting
(section 3.1.6.1.2).
3.1.6.1.2 Start value of output 1
This screen allows the user to set
the Start value of Output
1,(considerd as DC Current).
Start value of Output can be set
up to 20% of End value of Output.
Pressing the “ Down” key will
enter the “ New/Change Start
value of the Output 1 edit” mode.
Pressing “ Up” key will confirm the present value as Start
value of the Output 1 and advance to the selection of Elbow
value of Output1 (section 3.1.6.1.3) or Output 2
Characteristics setting (section 3.1.6.2)
A
24
To Next Page
Loading...