voltage or current.
Pressing the “ Down” key will
enter the “output 2 type edit”
mode and scroll between
voltage and current.
Pressing “ Up” key accepts
the present type for Output 2
and advance to the Input
Characteristics setting (section 3.1.5).
Output 2 Type confirmation
Pressing “ Down” key will re-
enter into Output 2 type Edit
mode.
Pressing the “ Up” key will set
the type and advance to the
Input Characteristics setting
(section 3.1.5).
3.1.5. Input characteristics Setting
3.1.5.1 End value of Input
This screen allows the user to set
the End value of Input. End
value of Input can be set from
50% to 120% of set CT
secondary value.
Pressing the “ Down” key will
enter the “New/Change End
value of Input edit” mode.
Note: After Changing Output Type please insure to change
DIP Switch setting (Refer Section 3.3.1). If DIP Switches are
already change then switch ON/OFF Transducer.
17
A
To Next Page
Loading...