Rishabh RISH CON - I - Output 2 Characteristics Selection; End Value of Output 2; Start Value of Output 2

Pressing the “ Up” key will confirm New Elbow value of
the Output 1 and advance to the Output 2 Characteristics
setting (section 3.1.6.2).
3.1.6.2 Output 2 Characteristics selection
3.1.6.2.1 End value of output 2
This screen allows the user to set
the End value of Output 2,
(considerd as DC Voltage).
The End value of Voltage Output is
fixed at 10V.
Pressing the “ Down” key, value
remains constant because end
value is fixed.
Pressing “ Up” key will set the present value as End value
of the Output 2 and advance to the Start value of Output
setting (section3.1.6.2.2).
3.1.6.2.2 Start value of output 2
This screen allows the user to set the Start value of Output
2,(considerd as DC Voltage).
Start value of output can be set up to 20 % of End value of
Output.
Pressing the “ Down” key will
enter the “New/Change Start
value of the Output 2 edit” mode.
Pressing “ Up” key will confirm
the present value as Start value of
the Output 2 and advance to the
Elbow value of Output setting
(section 3.1.6.2.3) or exit setup
menu.
29