Rishabh RISH CON - I - Programming via Front LCD & Two keys; Programming Port Configuration; RS485 (MODBUS) Programming

Screen 5 : Current Input and Screen 6 : Current Input &
Output 2 as Voltage Output 2 as Current
l
3. Programming
3.1 Programming via Front LCD & Two keys
The following sections comprise step by step procedures for
configuring the Current Transducer for individual user
requirements.
To access the set-up screens press & hold the“ down” &
“ up” keys simultaneously for 5 seconds. This will take the
User into the Password Protection Entry Stage .
Programming of transducer can be done in three ways :
3.1. Programming Via Front LCD & two keys.
3.2. Programming Via Programming port available at front of
Current transducer using option PRKAB60 Adapter.
3.3. Programming Via optional RS485(MODBUS)
communication port.
5