depending on set value of End
value of Input.
Pressing the “ Up” key will
advance the operation to the next
digit and set the third digit, in this
case to “1”.
Enter New / Change Elbow value
of the Input, third digit entered,
prompting for fourth digit.
(*denotes that digit will be
flashing).
Pressing the “ Down” key will
scroll the value of the fourth digit
from 0 through to 9, the value will
wrap from 9 round to 0 .
Pressing the “ Up” key will advance the operation to the
“New / Changed Elbow value of the Input confirmation” and
set the fourth digit, in this case to “0”.
New/changed Elbow value of the Input confirmed.
Pressing the “ Down” key will
re-enter to the “New / Change
Elbow value of the Input”.
Pressing the “ Up” key will
confirm New Elbow value of the
Input and advance to the Output
Characteristics setting (section
3.1.6).
23
To Next Page
Loading...