Rishabh RISH CON - I - New; Change Elbow Value of the Output 1

A
A
*
A
*
Pressing the “ Down” key will
enter the“ New/Change Elbow
value of the Output1 edit” mode.
Pressing “ Up” key will set the
present value as Elbow value of
the Output 1 and advance to the
Output 2 Characteristics
setting (section 3.1.6.2).
New / Change Elbow value of the Output 1
(*Denotes that digit will be
flashing)
Pressing the “ Down” key will
scroll value of the first digit from 0
through 2, value the value will
wrap from 2 round to 0.
Pressing the “ Up” key will
advance the operation to the next
digit and set the first digit, in this case to “1”.
Enter New / Change Elbow value
of the Output 1, first digit
entered, prompting for second
digit. (*Denotes that digit will be
lashing).
Pressing the “ Down” key will
scroll the value of the second
digit from 0 through to 9, the
value will wrap from 9 round to 0
depending on the set End value of Output.
Pressing the “ Up” key will advance operation to the next
digit and set the second digit, in this case to “1”.
27