RS 485 Parity confirmation
Pressing “ Down” key will be re-
enter into Parity Edit mode.
Pressing the “ Up” key will set the
value and advance to the Output
Type selection (section 3.1.4).
3.1.4. Output Type Selection
3.1.4.1 Output 1 Type selection
This screen allows the user to set
the output 1 type as Voltage or
Current.
Pressing the “ Down” key will
enter the “output 1 type edit”
mode and scroll between voltage
and current.
Pressing “ Up” key will confirm
the present type for Output 1 and advance to the Output 2
type selection (section 3.1.4.2).
Output 1 Type confirmation
Pressing “ Down” key will re-
enter into Output 1 type Edit
mode.
Pressing the “ Up” key will set
the type and advance to the
Output 2 type selection(section
3.1.4.2).
3.1.4.2 Output 2 Type Selection
This screen allows the user to set the output 2 type as a
16
To Next Page