Rishabh RISH CON - I - RS 485 Set-Up Code

This address is used to set the simulation
Output B to 10% of Output by writing 1000
and 100% of Output by writing 10000 .
This address is used to set the Baud
rate, Parity, No of Stop bits.
This address is used to set & reset the
password. Valid Range of Password can
be set is 0000 - 9999
This address is used to set the simulation
Output A to 10% of Output by writing 1000
and 100% of Output by writing 10000 .
This address is used to set the Analog O/P
Type 1 as Voltage/Current.
Voltage = 1 ,Current = 2.
This address is used to set the Analog
O/P Type 2 as Voltage/Current.
Voltage = 1 , Current = 2.
40017
RS 485
Setup
40019
Password
40027
Sim_
Output A
40029
Output B
Sim_
40031
Analog O/P
Type 1
40035
Analog O/P
Type 2
This address is used to set the Device
Address between 1 to 247.
40015
Device
Adress
Note: After Changing Analog Output Type1/Type 2 please
insure to change DIP Switch setting (Refer Section 3.3.1). If
DIP Switches are already change then switch ON/OFF
Transducer.
Table 4 : RS 485 Set-up Code
47
19200
19200
19200
9600
19200
NONE
NONE
ODD
EVEN
NONE
Baud Rate Parity
Stop Bit
Decimal value
01
01
01
01
02
13
14
15
08
12