3. COMMUNICATION INITIAL IDENTIFIER
IMCB04-E9
25
ID: Identifier (RO: Read only R/W: Read/write)
Name ID Data range Factory
set value
R/W
Control action type selection [SL6] CA 0 to 15 See *3
To vary
depending on
the
specification
R/W
Energized/de-energized alarm
selection, special specification
selection 1 [SL7]
Z1 0 to 15 See *4 0 R/W
Special specification selection 2 [SL8] Z2 0: Z-185 specification not
provided
2: Z-185 specification provided
0R/W
Special specification selection 3 [SL9] Z3 0 to 14 See *5 0 R/W
Option selection [SL10] DH 0 to 15 See *6 0 R/W
SV alarm type selection [SL11] XC 0 to 15 See *7 0 R/W
Setting limiter (high limit) [SLH] XV See input range table
(P.17 to 19)
To vary
depending on
R/W
Setting limiter (low limit) [SLL] XW
the
specification
Setting the position of decimal point
[PGdP]
XU 0: No digit below decimal point
1: 1 digit below decimal point
2: 2 digits below decimal point
3: 3 digits below decimal point
1R/W
Differential gap setting of ON/OFF
action [oH]
MH For TC/RTD inputs:
0 (0.0) to 100 (100.0) °C [°F]
For voltage/current inputs:
0.0 to 10.0 % of span
See *8 R/W
Differential gap setting of first alarm
(ALM1) [AH1]
HA For TC/RTD inputs:
0 (0.0) to 100 (100.0) °C [°F]
For voltage/current inputs:
0.0 to 10.0 % of span
See *8 R/W
Differential gap setting of second
alarm (ALM2) [AH2]
HB
CT ratio setting [CTr] XR 0 to 9999 See *9 R/W
Digital filter setting [dF] F1 0 to 100 seconds 0 R/W
Continued on the next page.
To Next Page
Loading...
