GX-3R Operator’s Manual Chapter 4: Display Mode • 37
2 . Press and release AIR to enter the screen. The current gas flashes at the bottom of the
screen.
3 . Use AIR to scroll through the list of gases.
4 . When the desired gas is displayed, press and release POWER MODE. The changes are
saved and the instrument returns to the LIST screen.
5 . The gas formula displays at the bottom of the Measuring Mode screen. The gas selection
remains selected if you turn the instrument off and on again.
Changing the User ID (USER ID)
This screen only appears if DISP SET in User Mode is set to ON (factory setting) and if ID
DISP in Maintenance Mode is set to ON (factory setting is OFF).
Use this screen to select a user ID from the 128 user IDs that are stored in the GX-3R’s
memory. Before a user ID is selected on a brand new instrument, the user ID is “----------”.
The factory-installed user IDs have a “U_ID_XXX” format.
The user ID provides a way to identify the GX-3R user during a data logging session. If the
user ID is changed during an operating session, a new data session is initiated with the new
user ID attached to it.
User IDs can only be selected
in this menu item. In order to edit the 128 user IDs, you must
use the GX-3R Datalogging Program.
1 . After entering Display Mode, press and release POWER MODE until the USER ID
screen sequence appears.
2 . To change the User ID, press and release AIR. The current User ID flashes.
3 . Use AIR to scroll to the desired User ID.
U_ID_002
7:49
USEr Id
CHG / AIR
7:49
USEr Id
NO / MODE
7:49
USEr Id
To Next Page
Loading...
Need help?
General
