GX-3R Operator’s Manual Chapter 4: Display Mode • 39
Last Successful Calibration Date (CAL DATA)
The CAL DATA screen shows the date of each installed sensor’s last successful calibration.
This screen only appears if CAL.RMDR is set to ON in User Mode.
1 . After entering Display Mode, press and release POWER MODE until CAL DATA
appears.
2 . Press AIR to enter the CAL DATA screen and to scroll through the installed sensors.
3 . When you are done viewing the last calibration date for the sensors, press and release
POWER MODE to return to the CAL DATA screen in Display Mode.
CAL DATA
7:49
CH4
18- 12. 20
CAL DATA
7:49
O2
18- 12. 20
CAL DATA
7:49
H2S
18- 12. 20
CAL DATA
7:49
CO
18- 12. 20
AIR AIR
AIR
AIR
To Next Page
Loading...
