38 • Chapter 4: Display Mode GX-3R Operator’s Manual
4 . Press and release POWER MODE to save the User ID and return to the USER ID screen
in Display Mode.
Changing the Station ID (STN ID)
This screen only appears if DISP.SET in User Mode is set to ON (factory setting) and if ID
DISP in Maintenance Mode is set to ON (factory setting is OFF).
Use this screen to select a station ID from the 128 station IDs that are stored in the
GX-3R’s memory. Before a station ID is selected on a brand new instrument, the station ID is
“----------”. The factory-installed station IDs have a “S_ID_XXX” format.
The station ID provides a way to identify the GX-3R location during a data logging session. If
the station ID is changed during an operating session, a new data session is initiated with the
new station ID attached to it.
User IDs can only be selected in this menu item. In order to edit the 128 user IDs, you must
use the GX-3R Datalogging Program.
1 . After entering Display Mode, press and release POWER MODE until the STN ID screen
sequence appears.
2 . To change the Station ID, press and release AIR. The current Station ID flashes.
3 . Use AIR to scroll to the desired Station ID.
4 . Press and release POWER MODE to save the Station ID and return to the STN ID
screen in Display Mode.
S_ID_002
7:49
Stn Id
CHG / AIR
7:49
Stn Id
NO / MODE
7:49
Stn Id
To Next Page
Loading...
Need help?
General
