GX-3R Operator’s Manual Chapter 5: User Mode and Calibration • 55
10 . Allow the gas to flow for 1 minute.
11 . Press and release POWER MODE.
12 . Follow the flow chart to determine the calibration outcome.
Figure 9: Calibration Flow Chart
Y N
Multiple Cylinders
Y N
Assigned?
A
B C
Y N
Auto start after successful
cal
set to on? (default is on)
D
*NOTE: Auto start after successful cal parameter set using Datalogging or SDM-3R PC Programs.
Calibration passed?
To Next Page
Loading...
