3: Fitting Hardware Options
56
Caution:-
A heatsink is used to dissipate heat from the processor so it may be HOT.
2. Lift the lever of ZIF socket and remove processor. Replace with
new upgrade processor. Ensure that pin 1 (marked with dot or
corner cut) is located correctly.
3. Replace the original heatsink or fit the small fan supplied with
the upgrade onto the new upgrade processor. Move any link
settings required.
4. Replace the cover of the computer (see page 44) and reconnect
your system as shown on the “Setting Up Your New Computer”
card.
5. Check on start-up that the correct processor type and speed is
detected.
Drive Upgrades
Your C-Series computer can have a number of different drive
upgrades. There is space for up to two external drives. The
external drive upgrades could be any of the following:-
• ZIP drive
• CD-ROM drive
• tape backup unit
Note:
Your computer may have been supplied with additional drives as fitted options.
Specific fitting instructions are provided with all drive upgrades.
Fitting a Drive
These instructions assume you have removed the cover according
to the instructions given on page 43.
To Next Page
Loading...
