3: Fitting Hardware Options
54
Removing a DIMM
1. Remove the cover (see page 43).
2. Using your fingers, push the plastic retaining clips down and
away from the DIMM to release it from the socket. The
released DIMM can then be lifted up and out of the slots at
either end of the DIMM socket. Take care not to damage the
socket when removing the DIMM.
3. Replace the cover of the computer (see page 44) and reconnect
your system as shown on the “Setting Up Your New Computer”
card.
4. When you switch on your computer, the system automatically
detects the extra memory and updates the CMOS RAM.
On some models you may need to enter the Setup program to
confirm the CMOS RAM, in this case the following message is
displayed:
RUN SETUP UTILITY
Press <F1> to RESUME
Press <F1> to run Setup. Enter your password, if the system
prompts you to do so (for default password see page 80). At the
main menu, save the changes. The system will reboot.
To Next Page
Loading...
