EasyManua.ls Logo

RM C-Series - Moving and Re-Packing the Computer

RM C-Series
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4: Maintenance, Service and Troubleshooting
60
Make sure that no liquid seeps into any of the equipment especially
the inside of the computer or keyboard so keep food and liquids
away. Avoid using aerosols or strong cleaning agents.
Do not use a damp cloth to clean floppy disks.
Do not attempt to clean the interior of the computer. This service
should only be performed by a fully qualified RM technician.
Moving and Re-packing the Computer
If you need to move your computer a short distance - to an
adjoining room for example - disconnect all equipment connected
to the computer.
1. Ensure that the floppy disk drive LED is off and remove any
floppy disks from the floppy disk drive(s).
2. Close down the operating system then check that the hard disk
drive LED is off.
3. Switch off your computer, the monitor and any other equipment
attached to it.
4. Disconnect any equipment from your computer and disconnect
the computer from the mains.
5. Prepare the new surface to put your computer on. It should be
flat, firm and dry.
6. Carefully lift your computer and put it down gently at its new
location.

Table of Contents

Related product manuals