1 Introduction
MANUAL TME400-VCF · EN08 · July, 01
st
2021
•
Read this operating manual and especially the following safety notices care-
fully before working with the device for the first time.
•
Warnings are provided in the operating manual for unavoidable residual risks
for users, third parties, equipment or other property. The safety instructions
used in this manual do not refer to unavoidable residual risks.
•
Only operate the device in fault-free condition and in observance of the operat-
ing manual.
•
Compliance with local statutory accident prevention, installation and assembly
regulations is also mandatory.
All notices in the manual must be observed. Use of the TME400 is only per-
mitted in accordance with the specifications in the operating manual. RMG
assumes no liability for damages arising due to disregard of the operating
manual.
Service and maintenance tasks or repairs that are not described in the oper-
ating manual must not be carried out without prior consultation with the
manufacturer. The device must not be opened forcefully.
The TME400 is approved for custody-transfer applications. For this purpose,
it is sealed before deliver and settings specified by the approval authority are
locked. These seals, software or hardware locks must not be damaged, de-
stroyed or removed!
In this case, the TME400 loses its official certification!
The TME400 can only be approved for officially certified operation after a re-
newed inspection by an officially recognized inspection authority or calibra-
tion officials and an additional inspection of additional settings. The calibra-
tion official must re-apply the seals after the inspection.
To Next Page
Loading...
Need help?
General
