1 Introduction
MANUAL TME400-VCF · EN08 · July, 01
st
2021
1.2.6.
Applicability of the manual
This manual describes the TME400. TME400 is generally only part of a complete
system. The manuals of the other components of the system must be observed. If
you find contradictory instructions, contact RMG and/or the manufacturers of the
other components.
Ensure that the power data of the current connection matches the specifica-
tions on the type plate. Ensure that the limit values specified in the conform-
ity certificate (see appendix) for the devices to be connected are not ex-
ceeded.
Observe any applicable national regulations in the country of use. Use cable
that is appropriate for the cable fittings.
Only work on the equipment if you have the appropriate training and qualifi-
cations.
Attention: Risk of destruction due to body electricity, e.g. due to the rubbing
of clothing.
1.2.6.1.
Danger during operation
Observe the specifications of the system manufacturer and/or system operator.
1.2.6.2.
Dangers of operation in EX areas
Only operate the device in fault-free and complete condition.
If you make technical changes to the device, safe operation can no longer be guaran-
teed.
Only use the device in its original condition. The TME400 is permitted for op-
eration in Ex Protection Zone 1, but only within the permissible temperature
range (chapter 1.3.4.2 Temperature ranges).
To Next Page
Loading...
Need help?
General
