Risk of injury during transport
Any foot screws must be mounted if they are provided as a transport safe-
guard to prevent rolling and tipping. Additional measures must be taken to
ensure that impermissible rolling and tipping are prevented.
Only use the provided lifting eyes / ring screws to lift the meter. Please ob-
serve the relevant permissible loads for the lifting equipment. Prior to lifting,
ensure that the load is securely fastened. Do not stand under suspended
loads.
The device can slip, topple over or fall down when being lifted and set down.
The device can fall over if the bearing capacity of the lifting equipment is dis-
regarded. There is a risk of severe injury for nearby persons.
If the device is delivered on a Euro pallet, the device can be transported on
the pallet using a pallet truck or forklift.
The gas meters and accessories must be protected from jarring and vibra-
tions during transport.
The gas meters or any inlet/outlet pieces have a flange as an end piece. The
flanges are sealed with a protective sticker or fitted with a plastic dummy
plug. The protective stickers and/or dummy plugs must be removed without
leaving any residue prior to installation in the pipeline. Residue from this film
changes the flow and causes measuring errors!
This protection must be re-applied to the flanges for transport or storage of
the device.
1.2.8.
The scope of delivery can differ depending on the optional orders. The following is
To Next Page
Loading...
Need help?
General
