RMG TME400-VMF - Symbols; Structure of Notices

1 Introduction
Manual TME400-VMF · EN02 · 2018 September 6th
3
MessEG
Measurement and Calibration Act
Law on the marketing and provision of measuring devices in the
market, their use and calibration, valid since 1/1/2015
MessEV
Measurement and Calibration Regulation
Regulation on the marketing and provision of measuring devices in
the market and on their use and calibration; 12/11/2014
MID
Measurement Instruments Directive
PTB
Physikalisch-Technische Bundesanstalt
[German National Test Authority]
Vo
original meter reading (Volume) of a mechanical counter
approx.
approximately
max.
maximum
min.
minimum
1.2.2.
Symbols
The following symbols are used:
1, 2, …
Identifies steps for work tasks
..
1.2.3.
Structure of notices
The following notices are used:
Danger
This warning notice informs you of imminently threatening dangers that can
arise due to misuse/operator error. If these situations are not avoided, death
or severe injuries can occur.