RMG TME400-VMF - Page 52

3 TME400
Manual TME400-VMF · EN02 · 2018 September 6th
46
Figure 9: Battery holder
The battery can be removed vertically in relation to the battery holder by pulling
slightly. When installing the new battery, ensure that the polarity is retained for the
new battery.
Danger
The battery must only be replaced in a non-explosive atmosphere. Ensure
that the electronics are supplied with adequate ventilation with fresh air.
Note
You can also have the battery replaced by the RMG Service department;
please contact RMG for this purpose (see page 2).
Please only use the battery types intended by RMG.