Robox RBX01 - Advanced Nozzle Settings

6767
www.cel-robox.com
5.0 AutoMaker Soware
5.5.7 Advanced Settings - Nozzles
These settings allow you to adjust all the parameters which aect the
operation of the nozzles and needle valves. By tuning these values, users
can control the appearance of start/stop points and surface finish, as well as
dramatically aecting print speed through the use of the larger fill nozzle.
1 Perimeter Nozzle Selection 7 Ejection Volume
2 Fill Nozzle Selection 8 Wipe Volume
3 Support Nozzle Selection 9 Partial Open Value
4 Support Interface Nozzle 10 Retract Length
5 Fine Nozzle Settings (0.3mm) 11 Retract/Unretract Speed
6 Fill Nozzle Settings (0.8mm) 12 Help Text
1
5
2
6
9
3
7
10
12
4
8
11