Robox RBX01 - Advanced Support Settings

7070
www.cel-robox.com
5.0 AutoMaker Soware
5.5.8 Advanced Settings - Support
This settings page allows you to adjust all the parameters which aect the
automatic generation of support material. Support material is required
where objects are being built in mid-air due to an overhang.
1 Generate Support Material 5 Pattern Spacing
2 Overhang Threshold 6 Pattern Angle
3 Force Support for First ... Layers 7 Help Text
4 Support Pattern
• Generate Support Material
This turns automatic support material generation on and o.
• Overhang Threshold ( ° )
This angle specifies the angular size of an overhang over which support
material is generated. Setting this value to ‘0’ tells AutoMaker to determine
this value automatically.
• Force Support for First ... Layers
This forces AutoMaker™ to generate support material for the first n layers
regardless of the overhang threshold setting.
1
5
2
6
3
7
4