www.cel-robox.com
5.0 AutoMaker Soware
• Enable Automatic Cooling
This setting is used to enable or disable automatic cooling for 3D prints.
AutoMaker™ uses one of two methods to control cooling - it can either
increase the fan speed or slow down the time to print a layer. The choice of
which method is used is controlled by ‘Enable Fan if Layer Time <’ and ‘Go
Slow if Layer Time <’.
• Minimum Fan Speed (%)
This sets the minimum fan head speed as a percentage of full power.
• Maximum Fan Speed (%)
This sets the maximum fan head speed as a percentage of full power.
• Bridges Fan Speed (%)
This sets the fan speed which is used when printing bridges as a percentage
of full power.
• Disable Fan for First n Layers
This disables the head fan when printing the first n layers, this can help with
adhering the first layer to the bed. It is recommended to leave it o for the
first 1 or 2 layers.
• Enable Fan if Layer Time < (seconds)
This will increase the fan speed to maximum if the layer time takes less than
the specified value in seconds.
• Go Slow if Layer Time < (seconds)
This will slow down the print speed if the layer time takes less than the
specified value in seconds.
• Minimum Print Speed (mm/s)
This setting is a lower limit on how slowly a layer can be printed in
millimetres per second.
• Help Text
This box displays a brief explanation of the setting which is highlighted
(changes on mouseover).
To Next Page
Loading...