Robustel GoRugged R3000 Quad User Guide
RT_UG_R3000 Quad_v.1.2.0 02.07.2015 44 / 136
Confidential
Remote IP Address @
PPPoE
PPPoE client will only accept the acknowledge from the PPPoE server
with this IP address.
Select from “Auto”, “PAP” and “CHAP” as the local ISP required.
Enable to obtain the DNS server’s address from the ISP.
Address/Control
Compression @ PPPoE
Used for PPP initialization. In general, you need to enable it as default.
Protocol Field
Compression @ PPPoE
Used for PPP initialization. In general, you need to enable it as default.
One of the PPP initialization strings. In general, you don’t need to
modify this value.
Maximum Transmission Unit. It is the identifier of the maximum size of
packet, which is possible to transfer in a given environment.
Maximum Receiving Unit. It is the identifier of the maximum size of
packet, which is possible to receive in a given environment.
Link Detection Interval
@ PPPoE
Specify the interval between PPPoE client and server.
To check the connectivity of PPPoE, the client and server regularly send
PPP Echo to each other. If the client or server receives no response from
the peer within a specified period of time, it retransmits the PPP echo. If
it receives no response from the peer after transmitting the PPP echo
for max retries times, it considers that the connection is down and tries
tore-establish the connection with the peer.
Link Detection Max
Retries @ PPPoE
Specify the max retries times for PPPoE link detection.
You can enter some other PPP initialization strings in this field. Each
string can be separated by a space.
Select to enable the DMZ function on LAN2.
Set the IP address of LAN2.
Maximum Transmission Unit. It is the identifier of the maximum size of
packet, which is possible to transfer in a given environment.
To Next Page
Loading...
