Robustel R1510 User Manual

Robustel R1510 User Guide
RT_UG_R1510_v.1.0.1 Dec. 31, 2019 55/140
Advanced Settings @ Access Point
Item
Description
Default
Max Associated Stations
Set the max number of clients allowed to access the router’s AP.
64
Beacon Interval
Set the interval of time in which the router AP broadcasts a beacon
which is used for wireless network authentication.
100
DTIM Period
Set the delivery traffic indication message period and the router AP
will multicast the data according to this period.
2
RTS/CTS Threshold
Set the threshold of “request to send”, which is the request to send a
threshold. When the threshold set as 2347, the router AP will not
send detection signal before sending data. And when the threshold
set as 0, the router AP will send detection signal before sending data.
2347
Fragmentation Threshold
Set the fragmentation threshold of a WiFi AP. It is recommended that
you use the default value 2346.
2346
Transmit Rate
Specify the data transfer rate or default to automatic.
Auto
11N Transmit Rate
Specifiy the data transfer rate in IEEE 802.11n WiFi mode or default
to automatic.
Auto
Transmit Power
Select the transmit power level. Select from “Max”, “High”,
“Medium” or “Low”.
Max
Channel width
Optional channel width is "Auto", "20MHz" or "40MHz".
Note: The 40MHz channel bandwidth provides an available data
transfer rate that is more than twice that of a single 20MHz channel.
Auto
Enable WMM
Click the toggle button to enable/disable the WMM option.
ON
Enable Short GI
Click the toggle button to enable/disable the Short Guard Interval
option. Short GI is a blank time between two symbols, providing a
long buffer time for signal delay. Using the Short GI would increase
ON

Robustel R1510 Specifications

General

Brand	Robustel
Model	R1510
Category	Network Router
Language	English