Robustel R1510 User Manual

Robustel R1510 User Guide
RT_UG_R1510_v.1.0.1 Dec. 31, 2019 56/140
Advanced Settings @ Access Point
Item
Description
Default
11% in data rates, but also result in higher packet error rates.
Enable AP Isolation
Click the toggle button to enable/disable the AP isolation option.
When enabled, the router will isolate all connected wireless devices.
The wireless device cannot access the router directly via WLAN.
OFF
Debug Level
Select from “verbose”, “debug”, “info”, “notice”, “warning” or
“none”.
none
Click to add a MAC address to the Access Control List. The maximum count for MAC address is 64.
ACL Settings @ Access Point
Item
Description
Default
Enable ACL
Click the toggle button to enable/disable this option.
OFF
ACL Mode
Select ACL mode. Select from “Accept” or “Deny”.
 Accept: Only the packets fitting the entities of the “Access Control
List” can be allowed
 Deny: All the packets fitting the entities of the “Access Control
List” will be denied
Note: Router can only allow or deny devices which are included in
“Access Control List” at one time.
Accept
Access Control List @ Access Point
Index
Indicate the ordinal of the list.
--
Description
Enter a description for this access control list.
Null
MAC Address
Add a MAC address here.
Null
This section allows you to view the status of AP.

Robustel R1510 Specifications

General

Brand	Robustel
Model	R1510
Category	Network Router
Language	English