Roche Diagnostics
Urisys 1100® · ≥5.7 · Operator's Manual · 9.0
4. Software 17
4.3 Menu functions
Self check During self check at power-on, the analyzer automatically
checks that the program chip, the test strip tray transport
mechanism, the printer connection and optical system
are all OK. The test strip tray type is checked to ensure
that it correctly matches the strip type selected in the
menu.
u 5. Installation (23)
Calibration
For requesting calibration with Control-Test
®
M.
u 6. Calibration (29)
Linefeed Causes paper to advance. The linefeed is stopped by
pressing the left function key (Stop).
u 5. Installation (23)
New series For starting a new series of measurements at sequence
number 1. It is also possible to have an Automatic Patient
ID.
u 8.1 Overview (33)
Memory The analyzer can store up to 100 results together with
date and time of measurement, sequence number and
patient ID (if entered). Memory is automatically cleared
every time the date changes.
After memory has been erased, NO RESULTS STORED
is displayed when Memory is pressed. Pressing the
START button resumes Ready-to-Measure status.
MEMORY FULL! and the options Print/Send/Clear are
displayed when the memory is full. Memory must be
cleared before the analyzer can resume Ready-to-
Measure status.
Print results For generating a printout of stored results. The options
are as follows:
• All: All results in memory
• Last Series: The most recent series of readings
• Last one: The most recent reading
Printing can be repeated as often as desired. Printing can
be interrupted by pressing the left key (Stop), for
example to allow a new roll of printer paper to be inserted
(Linefeed), and subsequently resumed (Continue). The
analyzer resumes Ready-to-Measure status when the
Home key is pressed or when printing has finished.
To Next Page
Loading...
Need help?
General
