Rockwell Automation Allen-Bradley 856T-B24LC - Add POINT I;O Ethernet Adapter

22 Rockwell Automation Publication 856T-UM001B-EN-P - April 2021
Chapter 3 Configure the 856T-B24LC IO-Link Module
Add POINT I/O Ethernet
Adapter
1. Add POINT I/O to the project. The 1734-AENTR adapter is used in this
project.
To add device to the project, Studio 5000 must be in Offline mode.
2. In the controller organizer tree, find Ethernet under I/O Configuration
and right-click to select New Module...
3. The module window opens and shows the available modules. Use the
filter to select 1734-AENTR adapter and click Create.