Rockwell Automation Allen-Bradley 856T-B24LC - Parameter Tab

Rockwell Automation Publication 856T-UM001B-EN-P - April 2021 39
Chapter 4 IO-Link Parameters
Parameter Tab
The Parameter tab displays the parameter settings of the 856T-B24LC module
where you can configure the stack light by defining the type of modules (light
or sound) in this specific stack light arrangement. In addition, you can set
counter functions per circuit, select required alarms to be monitored and
execute system and standard commands as well.
The Parameter tab contains the following device information:
Table 6 - Parameter Tab
Parameter Description Value
Module Configuration
.Module 1 Type Allows the selection of the stack light module in the first position of the stack light (Bottom to Up) • No Module
• 856T Steady Light
• 856T Multifunction module
• 856T Rotating Module
• 856T Multi-color light Module
• 856T Steady/Flashing Beacon
• 856T Strobe beacon
• 856T Rotating Beacon
• 856T Multi-color beacon
• 856T Piezo Electric sounder
• 856T Transducer sounder
• 856T Recordable sound module
.Module 2 Type Allows the selection of the stack light module in the second position of the stack light (Bottom to Up)
.Module 3 Type Allows the selection of the stack light module in the third position of the stack light (Bottom to Up)
.Module 4 Type Allows the selection of the stack light module in the fourth position of the stack light (Bottom to Up)
.Module 5 Type Allows the selection of the stack light module in the fifth position of the stack light (Bottom to Up)
.Module 6 Type Allows the selection of the stack light module in the sixth position of the stack light (Bottom to Up)
.Module 7 Type Allows the selection of the stack light module in the seventh position of the stack light (Bottom to Up)
Circuit Configuration (Circuits 1…7)
.Cycle Counter
This parameter enables the cycle counter for this specific circuit and its value is incremented each
time that the circuit transitions from OFF to ON. This value is persisted in EEPROM and restored on
powerup.
ON= power cycle Counter ON
OFF= power cycle counter OFF
Standard Command- Reset
Counter
The IO-Link device resets the circuit counter (1…7) when the system command (0xA0…0xA6) is received
via the IO-link protocol. It also allows you to reset the counter that is associated with this circuit by
clicking Reset Counter in this tab of the AOP.