36 Rockwell Automation Publication 1756-UM542A-EN-P - September 2014
Appendix B 1756HP-TIME Module Status
Status Messages
The 1756HP-TIME module provides the following status messages on the
display.
Status Message Description
192.168.1.100 Indicates the IP address of the 1756HP-TIME module.
Source: X
Indicates the current time source being used.
The sources are GPS, IRIG-B, NTP, and PTP.
BOOTP Enabled
Indicates that BOOTP is currently active on the module.
Use a BOOTP server to set the IP address.
Sat Count X The GPS receiver is locked onto X number
of satellites.
No Time Lock The time has not been received.
Time Locked The module is locked to the selected time source.
Firmware update in progress, do not power down! Indicates that a firmware upgrade is in progress.
OK Indicates that the module is operating correctly.
RESET Indicates the module has received a reset command.
TEST
The module displays this on startup when it is performing
sel
f-diagnostics to make sure the hardware is working properly.
PTP Source X
Displays either the IP address (Ethernet CIP Sync) or slot number
(Back
plane CIP Sync) of the PTP source.
PTP Source Unreachable
Indicates that there is no PTP source on either the backplane or
Ethernet network.
NTP Source X Displays the IP address of the NTP Source
NTP Source Unreachable Indicates that there is no NTP
source on Ethernet network.
Please provide IRIG-B Year
The Output image does not have a valid year for the IRIG-B
signal.
BL. Err X - Y
An error has occurred in initializing the module. X is the error
code, and Y is the description of the error.
Err X - Y
An error has occurred during operation. X is the error code, and Y
is the
description of the error.
To Next Page
Loading...
Need help?
General
