Rockwell Automation Publication 2080-UM002L-EN-E - November 2021 229
Appendix C Quickstarts
Change Password
With an authorized session, you can change the password on a target
controller through the Connected Components Workbench software. The
target controller must be in Connected status.
6. On the Device Details toolbar, click Secure. Select Change Password.
7. The Change Controller Password dialog appears. Enter Old Password,
New Password and confirm the new password.
8. Click OK.
The controller requires the new password to grant access to any new session.
Clear Password
With an authorized session, you can clear the password on a target controller
through the Connected Components Workbench software.
1. On the Device Details toolbar, click Secure. Select Clear Password.
To Next Page
Loading...
