Rockwell Automation Publication 20B-IN017B-EN-P - September 2011 11
Preface
Important Initial Steps
Read and follow these statements before performing any service on the drive.
· Read and follow the precautions in Safety Precautions on page 9
.
· Identify components to be replaced using the figures in Component
Diagrams and Torque Specs on page 13.
· Remove protective shields only as necessary.
· Before disconnecting any wire or cable, verify that it is labeled. Also, when
removing components, note hardware type and location.
· When torquing any fasteners, use a colored marker or torque seal to mark
each screw after torquing so you know when all are done and to indicate
signs of any subsequent tampering.
· Refer to the product installation documentation for startup and other
instructions after servicing.
To Next Page
Loading...
