RF: Connection Control CMU
1100.4903.12 4.58 E-10
Connection Control
The popup menu Connection Control contains several tabs to configure the inputs and outputs of the
CMU and the respective signals in the RF function group and the trigger settings.
The menu group is activated via the softkey Connect. Control to the right of the header of each meas-
urement menu. The individual tabs (Analyzer, Generator, RF
, Sync., Trigger, I/Q-IF) can be ac-
cessed via the hotkey bar at the lower edge of the screen.
Analyzer Settings (Connection Control – Analyzer)
The Analyzer tab adjusts the RF input path to the expected input power (RF Max. Level) and sets the
center frequency of the RF analyzer. The CMU provides a softkey-oriented version of the Analyzer tab
and a table-oriented version with extended functionality. The Analyzer hotkey toggles between the two
versions if it is pressed repeatedly.
Softkey-Oriented Version
The softkey-oriented version of the Analyzer tab determines the maximum input level (RF Max. Level),
the way this level is defined (RF Mode) and the attenuation of the RF input path (RF Atten.). All settings
of this menu are also provided in the table-oriented version of the Analyzer tab; see section Table-
Oriented Version on p. 4.59 ff.
Fig. 4-27 Connection Control – RF analyzer settings (softkey)
To Next Page
Loading...
