CMU  Audio Generator and Analyzer (with Option CMU-B41) 
1100.4903.12 6.73  E-10 
Subsystem AFANalyzer... (Measured Values) 
The subsystem AFANalyzer... starts the audio analysis and returns the results. 
 
READ[:SCALar]:AFANalyzer[:PRIMary]?   Scalar Results 
READ[:SCALar]:AFANalyzer:SECondary?  Start single shot meas. and return results 
FETCh[:SCALar]:AFANalyzer[:PRIMary]? 
FETCh[:SCALar]:AFANalyzer:SECondary?  Read out meas. results (unsynchronized) 
SAMPle[:SCALar]:AFANalyzer[:PRIMary]? 
SAMPle[:SCALar]:AFANalyzer:SECondary?  Read out meas. results (synchron.) 
Return 
Description of parameters  Def. value  Def. unit  FW vers. 
PeakVoltage1 
RMSVoltage1 
DCVoltage 
Distortion  
PeakVoltage2 
RMSVoltage2 
Frequency 
0 V to 42.4 V 
0 V to 30 V 
–30 V to 30 V 
0% to 100% 
0 V to 42.4 V 
0 V to 30 V 
10 Hz to 204.8 kHz 
NAN 
NAN 
NAN 
NAN 
NAN 
NAN 
NAN 
V 
V 
V 
% 
V 
V 
Hz 
V2.10 
V2.12 
(last 3 
output 
values) 
Description of command 
These commands are always queries. They start a measurement and output all scalar measurement results (see 
also Fig. 6-1). These are: 
•  Peak1 and RMS1 value of AC voltage after first band pass and the weighting filter 
• DC voltage 
•  Total harmonic distortion 
•  Peak2 and RMS2 value of AC voltage after first band pass and second band pass (variable band 
pass)  
•  Frequency counter 
 
 
 
AF Generator (AFGenerator)  
The subsystem AFGenerator configures and controls the AF generator. It corresponds to the meas-
urement softkey Generator in the measurement menu Audio Analyzer/Generator and the associated 
input fields. 
 
INITiate:AFGenerator[:PRIMary]    AF Generator Control 
INITiate:AFGenerator:SECondary  Start AF generator, reserve resources    ⇒  RUN
ABORt:AFGenerator:[PRIMary] 
ABORt:AFGenerator:SECondary   Switch off AF generator, release resources ⇒  OFF 
Description of command  FW vers. 
These commands have no query form. They start and stop the AF generator, setting it to the status 
given in the top right column. 
Note:  A running multitone measurement must be aborted before the single tone AF generator is 
switched on. See note in section Audio Generator and Analyzer (with Option CMU-B41) 
on page 6.64.  
V2.10