Rohde & Schwarz FSW43 - Page 259

Measurements
R&S
®
FSW
259User Manual 1173.9411.02 ─ 19
Note: You can define the time values with a greater numerical resolution than is dis-
played; the values are only rounded for display.
Remote command:
[SENSe:]SWEep:EGATe:TRACe<k>:STARt<range> on page 780
[SENSe:]SWEep:EGATe:TRACe<k>:STOP<range> on page 781
5.8.5.3 Scaling for Statistics Diagrams
The diagram scaling for statistical measurements can be configured in the "Scaling"
dialog box, which is displayed when you select the AMPT key and then the "Scale
Config" softkey.
The remote commands required to perform these tasks are described in chap-
ter 11.5.8.4, "Scaling the Diagram", on page 782.
In statistical diagrams, the x-axis displays the signal level values (= y-axis in standard
display), while the y-axis displays the probability of the values.
X-Axis..........................................................................................................................260
└ Range........................................................................................................... 260
└ Ref Level.......................................................................................................260
└ Shifting the Display (Offset).......................................................................... 260
Y-Axis..........................................................................................................................260
└ Y-Unit............................................................................................................260
└ Y-Max / Y-Min............................................................................................... 260
Default Settings...........................................................................................................260
Adjust Settings............................................................................................................ 261
Statistical Measurements (APD, CCDF)